|
Pulse Output
This is a purpose starts to pulse output with the specifications of C1 (port), C2 (method), and S2 (startup frequency).In every pulse control cycle (4ms), the frequency is increased in the specified acceleration ratio S1, until it reaches the target frequency specified in S1. After the frequency reaches the target, it will stop accelerating and continue to pulse output in a uniform velocity.When the amount of pulse output reaches the point of deceleration, the frequency decreases at every pulse control cycle (4ms) until it reaches the startup frequency when the output stops.
Example for use PLS2
This is example when 0.00 is on will start pulse output go to port
output 0 is 100,000 pulse by signal have Acceleration 500 Hz/4ms
start at 200 Hz until 50 Hz. about interval signal come down 250 Hz
/4 ms by start speed to stand until 200 Hz will cut off send pulse
Memory |
Value |
Working |
D200 |
01F4 |
Acceleration Rate : 500 Hz/4 ms |
D201 |
00FA |
Deceleration Rate: 250 Hz/4 ms |
D202 |
C350 |
Target Frequency 50 Hz |
D203 |
0000 |
D204 |
86A0 |
Pulse Output amount:100,000 pul |
D205 |
001 |
D210 |
00C8 |
Start frequency 200 Hz |
D211 |
0000 |
|
|
|